26
5.5
LOg pLACEmENT
Logs must be placed in the exact location in heater. Do not change from the proper log positions.
It is not necessary to remove the cast front, however, this will make for a more simple log installation.
In order to assemble the log set, the glass door must be removed, see "CAST FRONT / GLASS DOOR
INSTALLATION AND REMOVAL" section.
fIGure 5.5a
loG locatING ScrewS
fIGure 5.5c
5.5.2 Place the hole in the underside of log #2 onto
the locating screw, on the left side of the
burner. The fibre burner is formed to cradle the
centre of the log.
W415-0547 / D / 11.14.08
WARNING
!
Heater may not function properly.
The logs are fragile and should be handled with care.
WARNING
!
fIGure 5.5b
bRACKET
5.5.1 Place the rear log, as shown, onto the rear log
support brackets. Ensure the cutout on the left
underside of the log, fits over the pilot
assembly. Bend the bracket on the left side to
help retain the rear log.
fIGure 5.5d
5.5.3 Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
5.5.4 Reinstall the glass door & front.