Set Up A Wireless Network - ZyXEL Communications P-870HN-51D Quick Start Manual

If no lights are on, check your connections. Make sure that
you have the power adaptor connected to the P-870HN-51D
and plugged in to an appropriate power source. Make sure
the power source is turned on. Turn the P-870HN-51D off,
wait for a few seconds and turn it back on. If the LEDs are
still off, contact your local vendor.

Set Up a Wireless Network

You can set up a wireless network using the following methods.
Using Wireless Protected Setup (WPS)
Press the WPS button on the P-870HN-51D's rear panel for more than 5
seconds to turn the WPS function on.
Follow these steps to add a WPS-enabled device to the wireless network
using the WPS/WLAN button.
6
Place the devices you want to connect near
1
one another.
1
Press the WPS button on the P-870HN-
2
51D.
The WPS/WLAN light blinks.
Press the WPS button on a compatible
3
device within 2 minutes of pressing the
button on the P-870HN-51D.
The WPS/WLAN light on the P-870HN-51D
shines steadily when connected.