ZyXEL Communications P-870HN-51D Quick Start Manual page 5

1. DSL: Use a telephone wire to connect this port to a telephone jack (or
the DSL or MODEM jack on a splitter, if you have one).
2. ETHERNET 1~4: Use an Ethernet cable to connect a computer to
one of these ports for initial configuration and/or Internet access.
3. Use the power adaptor provided with your P-870HN-51D to connect
an appropriate power source to this socket.
4. Attach the antenna onto the P-870HN-51D.
5. Push the power button to the on position.
Look at the LEDs (lights) on the front panel of the P-
870HN-51D.
• The PWR/SYS light blinks during start-up and is
green once the P-870HN-51D is ready.
• An ETHERNET light turns on if the corresponding
ETHERNET port is properly connected. An Ethernet
port's light blinks when the P-870HN-51D is sending
or receiving data through it.
• The WPS/WLAN light stays green when the
wireless LAN is ready. It blinks when the P-870HN-
51D is sending/receiving data through the wireless
LAN.
• The DSL light stays on if a physical DSL connection
exists and blinks when transmitting data.
The INTERNET light is green when Internet access
is available. Open your web browser, and go to a
website, such as http://www.zyxel.com. If the web
page opens correctly, your P-870HN-51D is ready
for you to use.
5