Roadside Emergencies; Hazard Warning Flashers; First Aid Kit; Warning Triangle - Ford TRANSIT Owner's Manual

HAZARD WARNING FLASHERS

The hazard warning button is located on
the instrument panel. Use it when your
vehicle is creating a safety hazard for other
motorists.
Press the button to turn on the hazard
warning function, and the front and rear
direction indicators will flash.
Press the button again to turn them off.
Note: If used when the engine is not
running, the battery will lose charge. There
may be insufficient power to restart your
engine.
Note: Depending on applicable laws and
regulations in the country for which your
vehicle was originally built, the hazard
warning flashers may flash if you brake
heavily.

FIRST AID KIT

Space is provided in the passenger's side
lower door bin.

WARNING TRIANGLE

Space is provided in the driver's side lower
door bin.

EMERGENCY EXIT

WARNING
Make sure that the roof rack and its
load do not obstruct the emergency
exit. Ask your dealer for advice on
roof racks suitable for your vehicle.
Break the glass with the hammer in an
emergency.
Transit (TTG) Vehicles Built From: 26-01-2015, CG3612en enGBR, Edition date: 12/2014, First Printing

Roadside Emergencies

143

FUEL SHUTOFF

WARNING
Failure to inspect and if necessary
repair fuel leaks after a crash may
increase the risk of fire and serious
injury. We recommend that the fuel system
be inspected by an authorized dealer after
any crash.
In the event of a moderate to severe crash,
your vehicle is fitted with a fuel pump
shut-off feature that stops the flow of fuel
to the engine. Not every impact will cause
a shut-off.
Should the engine turn off after a crash,
you may restart the engine by carrying out
the following.
Ignition Switch
1. Switch the ignition off.
2. Switch the ignition to position III.
3. Switch the ignition off.
4. Switch the ignition on again to
re-enable the fuel pump.
Note: Various system checks are
automatically carried out before the vehicle
will restart. if your vehicle fails to restart
after the third attempt, the system has
detected a fault that requires service. We
recommend you contact an authorized
dealer.
Keyless Starting
1. Without applying the brake pedal,
press and release the button once.
2. Press the brake pedal, and then press
and release the button once.
3. Without applying the brake pedal,
press and release the button once.
(If Equipped)