Pairing The Cordless Module And Accessories; Pairing A Dect Cordless Accessory With A Dect Cordless Module; Pairing A Bluetooth Accessory With A Bluetooth Module - Mitel 5320e User And Administrator Manual

5320e/5330e/5340e IP Phone SIP User and Administrator Guide

Pairing the Cordless Module and Accessories

Before using a cordless handset or headset, it must establish communication with the Cordless
Module using a procedure called pairing.

Pairing a DECT Cordless Accessory with a DECT Cordless Module

Notes:

An IP phone can have only one DECT Cordless Handset and one DECT Cordless Headset.

A cordless handset or headset can be paired with only one IP phone at a time.

Pairing a new cordless handset or headset with the IP phone overwrites the configuration of
any previous handset or headset

Pairing cannot be performed when the cordless device is already in use.
To pair a DECT cordless accessory:
1. Ensure that the battery of the cordless device to be paired is at least partially charged.
2. Press and hold the pairing button on the back of the Cordless Module (see page 43) for 5
seconds to activate phone pairing mode. The LED on the Cordless Module blinks. The
Cordless Devices application opens on the phone and prompts you to place the accessory in
pairing mode.
3. Press and hold the hookswitch on the side of the cordless handset (see page 47) or headset
(see page 51) for 5 seconds to activate accessory pairing mode. The LED on the cordless
accessory blinks. After a moment, the Cordless Devices application displays protocol,
firmware, hardware, and IPEI information for the device to be paired.
Note: If the LED on the Cordless accessory does not start to blink after 10 seconds, the
accessory requires charging or is still in factory battery saving mode (handset only). Place the
accessory on the charger and charge. The green LED starts to flash indicating that the
accessory is charging. It could take up to 60 minutes for the green LED to start flashing. Allow
the accessory to fully charge, approximately 3 hours.
4. Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator.
5. Press Close to exit.

Pairing a Bluetooth Accessory with a Bluetooth Module

Notes:

An IP phone can have one Bluetooth Handset and up to five Bluetooth headsets (or up to
six headsets if no handset is paired).

To pair a new Bluetooth Handset, you must first unpair the existing Bluetooth Handset.

Pairing cannot be performed when a Bluetooth device is already in use.
To pair a Bluetooth accessory:
1. Ensure that the battery of the Bluetooth device to be paired is at least partially charged.
- 45 -