Canon NP6320 Service Manual page 290

CHAPTER 3 MECHANICAL SYSTEM
3) Slide the grip plate in parallel to the body,
and adjust the registration at the front and
rear.
4) Tighten the four mounting screws on the
grip plate after adjustment.
5) Set the deck.
Note:
Slide it to the front, without releasing the
latch.
6) Make copies using the paper deck.
7) Repeat steps 3) to 6) if the registration is
outside the standards.
8) Fix the front cover so that the gap between
the front cover and pedestal frame is about
0.5 mm.
3-10P
COPYRIGHT © 1999 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Non-image width at
rear decreases, while
non-image width at
front increases.
Use the scales as guide
(printed on both sides); a
single scale moves the
registration by about 1 mm.
Figure 3-304P
0.5mm
(approx.)
Front cover
Figure 3-305P
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Non-image width at
front decreases,
while non-image
width at rear in-
creases.
Pedestal frame