Mitsubishi city multi PKFY-08NAMU-A Technical & Service Manual page 49

OPERATION PROCEDURE
9. REMOVING THE LINE FLOW FAN
(1) Remove the terminal block cover.
(2) Remove the front panel.(see the photo 1)
(3) Remove the electrical parts box.(see the photo 7)
(4) Remove the nozzle assembly.(see the photo 6)
(5) Remove the fan motor.(see the photo 8)
(6) Remove the pipe fixture with 2screws.(see the photo11)
(7) Remove the left / right screws of the heat exchanger and
pull the left-hand side up.
(8) Remove the 2screws by sliding it toward you remove the
fixture(fixing bearing).
w The fan motor is removable first , when the fan
removing is hard.
w When resetting the fan to the fan motor.
Locate and fix the shaft after installing the fan.
10. REMOVING THE HEAT EXCHANGER
(1) Remove the terminal block cover.
(2) Remove the front panel.(see the photo 1)
(3) Remove the electrical parts box.(see the photo 7)
(4) Remove the corner box.
(5) Remove the nozzle assemble.(see the photo 6)
(6) Remove the 2screws and the pipe fixture.
(7) Remove the 2screws and heat exchanger.
(Photo10)
Heat exchanger
Set screws
Fixture(fixing bearing)
(Photo 11)
Set screw
OC292-47
PHOTOS & ILLUSTRATION
Heat exchanger
Pipe fixture
Set screws