Table of Contents
Advertisement
REMOVING THE CONSOLE COMPONENTS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug dryer or disconnect power.
2.
Turn off gas supply to dryer.
3.
Remove the two T-15 Torx screws from
the console.
T-15 Torx Screws
4.
Slide the console to the front of the unit
slightly, then rotate it back and place it in
the "service" position.
Control Board And Display Board
(Below Control Board)
Freestanding Dryers
5.
ADVANTECH
Screw (1 of 6)
6.
Card Reader
4-26
To remove the ADVANTECH
board:
a) Disconnect the board connectors at
P1, P4, P8, and P11.
b) Disconnect the four wires at the dryer
motor relay K1 (RD & RD), and dryer
heater relay K2 (BU & BK).
c) Disconnect the green ground wire from
terminal P6.
d) Remove the six 5/16" hex-head screws
from the board and remove the board.
Control Board
P4
P11
P8
To remove the display board:
a) Remove the ADVANTECH
board (see step 5).
b) Disconnect the connector from the dis-
play board at P1.
c) Unlatch the display board from the
holder and remove it.
P1 Latch
control
Relays
P1
K2
K1
Ground Wire
control
Display Board
Advertisement
Table of Contents
