Lexmark 7500 Series User Manual page 149

Check cable
•
Make sure the power cable is connected to the printer and to the electrical outlet.
•
Make sure the USB cable or the installation cable is not connected.
Check Wi-Fi indicator light
Make sure the Wi-Fi indicator light is green. If it is not green, see "Wi-Fi indicator light is orange" or "Wi-Fi indicator
light is blinking orange during installation" in "Wireless troubleshooting."
Check if printer driver is installed
Make sure the printer driver is installed on the computer from which you are sending the print job.
1
Do one of the following:
•
In Windows Vista, click:
•
In Windows XP, click:Start
•
In Windows 2000 and earlier, click: Start
If you cannot find the icon for your printer, then the printer driver is not installed.
2
If the printer driver is not installed, insert the installation software CD into your computer.
3
Follow the instructions on the computer screen.
Note: You must install the printer driver on each computer that uses the network printer.
Check if printer is connected to the wireless network
1
Print a network setup page. For more information, see "Printing a network setup page."
2
Check to see if "Status: Connected" appears under Network Card.
Reboot the computer
Turn off and restart the computer.
Check printer ports
Make sure the correct printer port is selected.
1
Click:
•
In Windows Vista:
•
In Windows XP: Start
•
In Windows 2000 and earlier: Start
2
Right-click the Lexmark 7500 Series icon.
3
Click Properties Ports.
4
Verify that XXXX_Series_nnnnnn_P1 is selected, where XXXX is the model series number of your printer and
nnnnnn is the last six numbers of the MAC address of your printer.
Note: The MAC address is located at the back of the printer beside the serial number.
5
If USB is selected instead:
a
Select the port name from step 4.
b
Click Apply.
Control Panel
Settings Printers and Faxes.
Settings
Control Panel Printers.
Settings Printers and Faxes.
Settings
149
Printers.
Printers.
Printers.