Panasonic WJ-NV300K Operating Instructions Manual page 134

Set up VMD areas, etc. [VMD search setup]
Set up VMD areas within images and a mask duration.
Step 1
Display the images from the camera to search on a
1-screen. (☞ Page 109)
Step 2
Click the [Setup] button next to [Detection area /
Mask duration].
The "VMD search setup" panel will be displayed.
→ →
Step 3
Click 2 points of the upper left and lower right to cre-
ate a square to be set as the area on the displayed
image.
The set area will be displayed in gray, and the
→ →
area will become subject to be searched for
motion detection.
Note:
• As the detection areas will be set up to match the
image display area divided into 16x16 segments,
the top left and bottom right detection areas may
not be exactly as designated.
• It is impossible to delete the detection area that
has been set. To change the detection area set-
ting, perform Step 3 again.
Step 4
If VMD search takes too much time or the search pro-
duces too many results, set a mask duration to
reduce the search frequency. When mask duration is
set, no motion detection will be performed from the
time motion is detected to the time mask duration is
set.
To set, click the [C] button next to [Mask duration
setup] on the advances setup panel.
Mask duration: 1 s/ 5 s/ 10 s/ 30 s/ 1 min/ 5 min/
10min
Default: 1 s
Step 5
Click the [Back] button or the [x] button.
The display returns to the VMD search panel.
→ →
134