Record Images; Record Images (Schedule Recording) - Panasonic WJ-NV300K Operating Instructions Manual

Record images

Live images can be recorded on the recorder. Images from up to 32 cameras can be simultaneously recorded
with this recorder.

Record images (schedule recording)

Recording can be automatically started and stopped according to a previously specified schedule. Refer to
page 39 for schedule recording.
Note:
• When event recording is triggered by an alarm during the schedule recording, event recording has the
higher priority. Refer to the "Recording mode and its priority" section below for further information about the
priority of the recording mode.
• To stop schedule recording, stop the recording on the setup menu. Refer to page 48 for further information.
• In case of a network error, the image of the camera where the communication error has occurred will not be
recorded. Recording starts when the network error is recovered. If the status in which the communication
with the camera is disconnected recovers within around 40 seconds, error logs will not be saved.
• Schedule-recorded image data will be divided into multiple files every hour on the hour. In that moment,
recording may sometimes be interrupted around for 1 second.
Recording mode and its priority
There are 3 recording modes. The recording modes and their priority levels are as follows.
When two or more recordings with different recording modes started simultaneously, only recording with the
higher priority will start.
Recording mode
Event recording
Schedule recording
Pre-event recording
Network cameras
Priority
1
2
3
123
Image data
HDD
Recorder