Simplicity LTH series Service Manual page 194

7 Transmission Repair
7C Tuff Torq K60
5. Apply grease to the fulcrum arm and install new
packing.
6. Install the fulcrum arm into the case.
7. Install the washer and nut on the fulcrum shaft. Snug
the nut but do not tighten at this point.
8. Apply grease to the control shaft and install new
packing.
9. Install the torsion spring as shown, and install the
control shaft into the transaxle case.
10. Install the retaining ring on the control shaft on the
outside of transaxle
Figure C–60. Install Fulcrum Arm
Figure C–61. Install Fulcrum Washer and Nut
Figure C–62. Install Packing and Spring
7 - 64
Packing