Simplicity LTH series Service Manual page 178

7 Transmission Repair
7C Tuff Torq K60
18. Remove the cap from the expansion chamber reser-
voir to clear the frame. Slowly lower the jack to
remove the transaxle from the frame.
removed, replace the cap.
19. Remove the pulley, cam assembly, and support rods.
NOTE: When reinstalling input pulley, new setscrews
must be used. The setscrews have a special soft end
and cannot be reused.
NOTE: Early models do not have a snap ring retaining
the top of the pulley used by later models. For either
model, install a snap ring during reassembly.
Once
Figure C–15. Remove Transaxle From Frame
Figure C–16. Remove Pulley, Cam Assembly, Rods
7 - 48