Simplicity LTH series Service Manual page 152

7 Transmission Repair
7B Eaton 750 / 751
4. Reposition and support the cover with the input shaft
in the down position. Use a plastic hammer or arbor
press to remove the input shaft assembly from the
cover.
5. Using a screwdriver or similar tool, drive the input
shaft seal from the cover.
6. To remove the control shaft seal, reposition the
cover. Using a small screwdriver or a similar rod, pry
the control shaft seal from the cover assembly.
7. Remove the cover gasket from the housing and dis-
card.
NOTE: The gasket may have remained on the cover
when it was removed.
8. Remove the two buttons from the cam ring assembly.
NOTE: These buttons may have remained in the cover
assembly.
9. Remove the drive from the pump rotor assembly.
Figure B–44. Remove Input Shaft From Cover
Figure B–45. Remove Input Shaft Seal
Figure B–46. Remove Control Shaft Seal
Figure B–47 Remove Cam Ring Buttons
Figure B–48 Remove Pump Drive From Rotor Assy.
7 - 22