Simplicity LTH series Service Manual page 183

15. Remove the motor shaft assembly and the center
case sub-assembly.
16. While holding pistons into pump cylinder block with
your fingers, remove the cylinder block from the
pump input shaft.
17. Using a feeler gauge, measure the clearance
between the swash plate and the shift blocks.
Clearance: 0–0.008" (0–0.2 mm)
Wear limit: 0.012" (0.3 mm)
Note: An excess amount of clearance at these points
can make it difficult or impossible to adjust neutral.
Figure C–29. Remove Center Case Assembly
Figure C–30. Remove Pump Cylinder Block
Figure C–31. Measure Shift Block Clearance
7 - 53
7 Transmission Repair
7C Tuff Torq K60