Call Waiting; Temporary Tone Dialing; Find Handset; Redial List - VTech CS6419 User Manual

Call waiting

When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
/FLASH to put the current call on hold and take the new call.
• Press
/FLASH at any time to switch back and forth between calls.
• Press
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer, press OFF/
•
the handset. RINGER MUTED and

Temporary tone dialing

If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call.
. During a call, press
2. Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
3. The telephone automatically returns to pulse dialing mode after you end
the call.

Find handset

Use this feature to find all system handsets.
To start paging:
Press /FIND HANDSET on the telephone base once and then release.
•
All idle handsets ring and their screens show ** PAGING **.
To end paging:
Press /FIND HANDSET again on the telephone base once and
•
then release.
/
• Press
FLASH
• Place the handset in the telephone base or charger.
Do not press and hold /FIND HANDSET for more than four seconds. It may
lead to handset deregistration. If 1.PRESS FIND HS ON BASE 4 SEC and
2.THEN PRESS # ON HANDSET display alternately on the handset, refer
to Troubleshooting to register the handset to the telephone base.

Redial list

Each handset stores the last 0 telephone numbers dialed.
To review and dial a number from the redial list:
Press REDIAL/
.
Press , , or or REDIAL/
2.
/
3. Press
FLASH
To delete a redial entry:
When the desired redial entry displays, press

Join a call in progress

You can use up to two system handsets at a time on an outside call. You
can buy additional expansion handsets (CS6409) for this telephone base.
You can register up to five handsets to the telephone base.
• When a handset is on a call, press
join the call.
Press OFF/
•
CANCEL
hang up.
Intercom
Use the intercom features for conversations between two handsets.
Press INT on your handset when it is not in use. When you have
.
three or more handsets, use the dialing keys to enter a destination
handset number.
2. To answer the intercom call, press
(0-9,
TONE
To end an intercom call, press OFF/
3.
the telephone base or charger.
.
TONE
,
or any dialing key (0-9,
when the handset is not in use.
PAUSE
PAUSE
to dial.
to exit the call. The call continues until all handsets
, #) on the destination handset.
CANCEL
display.
TONE
repeatedly until the desired entry displays.
MUTE
or
/FLASH
/
FLASH,
or place the handset back in
CANCEL
6
or MUTE/
DELETE
or #) on the handset.
/DELETE.
on another handset to
, INT or any dialing key
on