Chamberlain 5410E 2013 Owner's Manual page 9

ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLY
Assemble the T-Rail and Attach the Chain Sprocket
Bracket
To avoid installation diffi culties, do not run the
garage door opener until instructed to do so.
1. Place the 3 T-rail sections on a fl at surface
for assembly. The end sections are identical.
Make sure the "arrow label" on the center
section is pointing in the direction shown in
the illustration.
2. Connect the center section and the 1/4" lock
nuts to the end sections from the same side,
as shown.
NOTE: If T-rail is not assembled exactly as
shown, trolley will not travel smoothly along length of rail or it
will hit against nuts.
3. Insert the carriage bolts from the opposite side of the end
sections. Tighten the nuts. When assembled, T-rail has a
front-to-back position as shown.
4. Position the chain sprocket bracket on the front end of the T-rail
as shown. Fasten securely with the hardware provided.
NOTE: When tightening the bolts be sure to keep bracket
parallel to the rail. Otherwise, the rail may bow when the opener
is operated.
Rail
(End Section)
Rail connects to
opener at this end.
Brace
Square Carriage
Bolt Holes
HARDWARE
SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
1/4'' Lock Nut
Brace
Rail
(Center Section)
Hex Bolts
Hex Bolts
5/16"-18x7/8"
5/16"-18x7/8"
Tuerca de 1/4"
9
Lock Nut Carriage Bolts
1/4"-20 1/4"-20x1/2"
Nut Lock Washer
5/16"-18 5/16"
11 mm Socket Wrench
Cable pulley bracket
Chain sprocket bracket
attaches to this
attaches to this end
end of rail.
of Rail
Rail
(End Section)
AWAY FROM
OPENER
Carriage Bolt
1/4"-20x1/2"
El sostén de la polea
Chain Sprocket
del cable se fija a este
Chain Pulley
Cable Pulley
Bracket
extremo del riel en "T".
Bracket
Bracket
Lock Washer
Lock Washer
Riel en "T"
5/16"
5/16"
(Sección Extrema)
Nut
Nut
5/16"
5/16"
13 mm Socket Wrench