Connect The Door Arm To The Trolley - Chamberlain 5410E 2013 Owner's Manual

ALL ONE-PIECE DOORS
1. Assemble the door arm, Figure 5:
IMPORTANT: The groove on the straight door arm MUST face
away from the curved door arm.
• Fasten the straight and curved door arm sections together to
the longest possible length (with a 2 or 3 hole overlap).
• With the door closed, connect the straight door arm section to
the door bracket with the 5/16"x1-1/4" clevis pin.
• Secure with a ring fastener.
2. Adjustment procedures, Figure 6:
On one-piece doors, before connecting the door arm to the
trolley, the travel limits must be adjusted. Limit adjust ment
screws are located on the left side panel as shown on page 28.
Follow adjustment procedures below.
• Open door adjustment: decrease UP travel limit
– Turn the UP limit adjustment screw counter-clockwise
5-1/2 turns.
– Press the Door Control push bar. The trolley will travel to
the fully open position.
– Manually raise the door to the open position (parallel to the
fl oor), and lift the door arm to the trolley. The arm should
touch the trolley just in back of the door arm connector
hole. Refer to the fully open trolley/door arm positions
in the illustration. If the arm does not extend far enough,
adjust the limit further. One full turn equals 5 cm of trolley
travel.
• Closed door adjustment: decrease DOWN travel limit
– Turn the DOWN limit adjustment screw clockwise
5 complete turns.
– Press the Door Control push bar. The trolley will travel to
the fully closed position.
– Manually close the door and lift the door arm to the trolley.
The arm should touch the trolley just ahead of the door
arm connector hole. Refer to the fully closed trolley/door
arm positions in the illustration. If the arm is behind the
connector hole, adjust the limit further. One full turn equals
5 cm of trolley travel.
Figure 6
Inner Trolley
Door Arm
Connector Hole
Door Arm
Closed
Door
Outer Trolley
Emergency Release Handle
Inner Trolley
Open Door
Figure 5
CORRECT
Straight
Door Arm
(Groove
facing out)
Door
Bracket
Straight
Clevis Pin
Arm
5/16"x1-1/4"
Bolts
5/16"-18x7/8

3. Connect the door arm to the trolley:

• Close the door and join the curved arm to the connector hole
in the trolley with the remaining clevis pin. It may be necessary
to lift the door slightly to make the connection.
• Secure with a ring fastener.
• Run the opener through a complete travel cycle. If the door
has a slight "backward" slant in full open position as shown in
the illustration, decrease the UP limit until the door is parallel
to the fl oor.
NOTE: When setting the up limit on the following page, the door
should not have a "backward" slant when fully open as illustrated
below. A slight backward slant will cause unnecessary bucking
and/or jerking operation as the door is being opened or closed
from the fully open position.
Door Arm
Correct Angle
27
INCORRECT
Straight
Door Arm
Curved
Door
Arm
Ring
Fastener
Nuts
Lock
5/16"-18
Washers
5/16"
Outer Trolley
Door with
Backward Slant (Incorrect)
Curved
Door
Arm
Curved
Door Arm