Assembly; Install The Trolley - Chamberlain 5410E 2013 Owner's Manual

ASSEMBLY STEP 2
For Sectional and One-Piece Doors Only
Install the Trolley on the T-Rail
• Attach the trolley threaded shaft to the trolley with the lock
washer and nuts as shown.
• As a temporary stop, insert a screwdriver into the hole in the
front end of the T-rail.
• Slide the trolley assembly along the rail to the screwdriver stop.
NOTE: If trolley hits against any nuts on the T-rail, the bolts
and nuts were attached from the wrong side and must be
repositioned. Review Assembly Step 1.
ASSEMBLY STEP 2
For Sliding and Swinging Gates Only
Install the Trolley on the T-Rail
• Attach the trolley threaded shaft to the trolley with the lock
washer and nuts as shown.
• Insert a hex bolt into the hole in the front end of the T-rail.
• Slide the trolley assembly along the rail until it rests against the
hex bolt (trolley stop).
NOTE: If trolley hits against any nuts on the T-rail, the bolts
and nuts were attached from the wrong side and must be
repositioned. Review Assembly Step 1.
Temporary Stop
Screwdriver
Hex Bolt
5/16"-18x7/8"
Hex Bolt
Trolley Stop
Lock Washer
5/16"
Inner Nut
5/16"-18
Inner Nut
5/16"-18
Lock Washer
5/16"
Outer Nut
5/16"-18
Trolley
HARDWARE SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
Inner Nut
5/16"-18
Outer Nut
5/16"-18
10
HARDWARE SHOWN ACTUAL SIZE
Lock Washer
Nut
5/16"
5/16"-18
Trolley
Threaded
Shaft
Nut Lock Washer
5/16"-18 5/16"
Trolley
Threaded
Shaft
Lock Washer
5/16"
Chain Sprocket
Chain Pulley
Bracket
Bracket