Determine The Header Bracket Location - Chamberlain 5410E 2013 Owner's Manual

Table of Contents

Advertisement

INSTALLATION STEP 1

Determine the Header Bracket Location

To prevent possible SERIOUS INJURY or DEATH:
• Header bracket MUST be RIGIDLY fastened to structural
support on header wall or ceiling, otherwise garage door
might NOT reverse when required. DO NOT install header
bracket over drywall.
• Concrete anchors MUST be used if mounting header bracket
or 38 mm board into masonry.
• NEVER try to loosen, move or adjust garage door, springs,
cables, pulleys, brackets, or their hardware, ALL of which are
under EXTREME tension.
• ALWAYS call a trained door systems technician if garage door
binds, sticks, or is out of balance. An unbalanced garage door
might NOT reverse when required.
Installation procedures vary according to garage door types.
Follow the instructions which apply to your door.
If your door is a canopy or dual-track style garage door, a
door arm conversion kit is REQUIRED. Follow the installation
instructions included with the replacement door arm sectional.
SECTIONAL DOOR AND ONE-PIECE DOOR WITH TRACK
1. Close the door and mark the inside vertical centerline of the
garage door.
2. Extend the line onto the header wall above the door.
You can fasten the header bracket within 1.2 m of the left
or right of the door center only if a torsion spring or center
bearing plate is in the way; or you can attach it to the
ceiling (see page 17) when clearance is minimal. (It may
be mounted on the wall upside down if necessary, to gain
approximately 1 cm.)
If you need to install the header bracket on a 38 mm board
(on wall or ceiling), use lag screws (not provided) to securely
fasten the 38 mm board to structural supports as shown here
and on page 16.
3. Open your door to the highest point of travel as shown. Draw an
inter secting horizontal line on the header wall 5 cm above the
high point. This height will provide travel clearance for the top
edge of the door.
Proceed to Step 2, page 17.
Header
Wall
Ceiling
Header
Wall
Highest Point
of Travel
Door
SECTIONAL DOOR
WITH CURVED TRACK
Highest Point
Header
of Travel
Wall
Track
Garage
Exterior
Door
ONE-PIECE DOOR
Track
WITH HORIZONTAL &
VERTICAL TRACK
15
Finished
Ceiling
38 mm
Board
Vertical
Centerline of
Garage Door
Header
Wall
Track
Door
ONE-PIECE DOOR
WITH HORIZONTAL
TRACK & JAMB
HARDWARE
Header
Wall
CANOPY ONE-PIECE
Track
DOOR WITH
VERTICAL TRACK
Structural
Supports
Highest Point
of Travel
Track
Jamb
Hardware
Highest Point
of Travel
Door

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents