Planning - Chamberlain 5410E 2013 Owner's Manual

Planning (Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require reinforcement.
If your door is lightweight, refer to the information relating to
sectional doors in Installation Step 10.
• Depending on your door's construction, you may need
additional mounting hardware for the door bracket (Step 10).
ONE-PIECE DOOR WITHOUT TRACK
Header
Wall
Gap between floor and bottom
of door must not exceed 6 mm.
Safety
Reversing Sensor
(Optional Accessory)
ONE-PIECE DOOR WITH TRACK
Safety Reversing
Sensor
(Optional Accessory)
Access
Door
Safety
Reversing Sensor
(Optional Accessory)
Access
Door
Safety Reversing
Gap between floor
Sensor
and bottom of door
(Optional Accessory)
must not exceed 6 mm.
Without a properly working safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
• The gap between the bottom of the garage door and the fl oor
MUST NOT exceed 6 mm. Otherwise, the safety reversal
system may NOT work properly.
• The fl oor or the garage door MUST be repaired to eliminate
the gap.
Support bracket
& fastening
hardware is required.
See page 20.
Cable
Chain Sprocket
Pulley Bracket
Bracket
Door
Bracket
Header
Wall
CLOSED POSITION
Cable
Chain Sprocket
Pulley Bracket
Bracket
Header
Wall
Curved
Header
Door Arm
Bracket
Straight
Door
Garage
Door
Bracket
Door
Arm
5
CLOSED POSITION
Trolley
Header
Bracket
Rail
Straight Curved
Door Door
Arm Arm
Garage
Door
Trolley Chain
Rail
Emergency Release
Rope & Handle
Emergency
Release
Rope & Handle