Ordering Replacement Parts; Wiring - Superior DRT6345TEN Installation And Operation Instructions Manual

INNOVATIVE HEARTH PRODUCTS • DIRECT-VENT GAS FIREPLACES (DRT6300/DRC6300) • CARE AND OPERATION INSTRUCTIONS

ORDERING REPLACEMENT PARTS

A complete parts list is found at the end of
this manual. Use only parts supplied from the
manufacturer.
With proper care and maintenance, your appli-
ance will provide many years of enjoyment. If
you should experience any problem, first refer
to the troubleshooting guide in this manual.
If problem persists, contact your Innovative
Hearth Products dealer or distributor.
Normally, all parts should be ordered through your
Innovative Hearth Products distributor or dealer.
Parts will be shipped at prevailing prices at
time of order.

WIRING

Wiring diagrams are provided here for refer-
ence purposes only. This information is also
provided on schematics attached directly to
the appliance on a pullout panel located within
the control compartment.
ELECTRONIC WIRING DIAGRAM
SCHEMATIC REPRESENTATION ONLY
(Schematic representation only)
COLOR CODE:
B = Black
BB = Brown w/Black Stripe
BG = Brown w/Green Stripe
BL = Blue
BR = Brown
G = Green
GY = Gray
O = Orange
R = Red
W = White
Y = Yellow
Figure 75—Wiring Diagram
46
When ordering repair parts always provide:
1. The model number of the appliance.
2. The serial number of the appliance.
3. The part number.
4. The description of the part.
5. The quantity required.
6. The installation date of the appliance.
If you encounter any problems or have any
questions concerning the installation or ap-
plication of this system, please contact your
dealer or distributor.
Fireplace Model Number ________________________________________________
Fireplace Serial Number _________________________________________________
Date Installed _________________________________________________________
Type of Gas Used in Fireplace ____________________________________________
Dealer Name _________________________________________________________
CAUTION: LABEL ALL WIRES PRIOR
TO DISCONNECTION WHEN SERVICING
CONTROLS. WIRING ERRORS CAN
CAUSE IMPROPER AND DANGEROUS
APPLIANCE OPERATION.
Battery Holder w/Switch
ON/ Remote
Main Wire
/OFF
Harness
Y
BR
G
Note: On models
without pressure
switch, these
connectors are
Y
Battery Holder
plugged together.
Wire Harness
Air Pressure Switch
Power Vent Only
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
885 Valve
Battery Holder with Switch
ON/Remote/OFF
B
O
R
BL
G
W
R B
Reset Switch
BL
(See instructions.)
R
O
G
B
GY
WH
B
W
G
Power Vent Blower
Power Vent
Models Only
PRODUCT REFERENCE INFORMATION
We recommend that you record the important
reference information about your fireplace in
the space provided below.
Please call Innovative Hearth Products for the
phone number of your nearest Innovative Hearth
Products dealer who will answer your questions
or address your concerns.
INNOVATIVE HEARTH PRODUCTS
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
Visit us at
SuperiorFireplaces.US.com
ATTENTION : AU MOMENT DE
L'ENTRETIEN DES COMMANDES,
ÉTIQUETEZ TOUS LES FILS AVANT DE
LES DÉBRANCHER. DES ERREURS DE
CÁBLAGE PEU-VENT ENTRAÎNER UN
FONCTIONNEMENT INADÉQUAT ET
DANGEREUX.
IPI Pilot
Pilot Tube
Optional
Split Flow
B
Control Module
Fuse
B B
W
Flame
Sensor
Spark
Electrode
B
Ground Y
G
Main Power Cord