Log Set And Ember Installation - Lennox Hearth Products EPIC33 Installation And Operation Manual

Log Set and Ember Installation

If logs are not installed according to the log installation
instructions, flame impingement and improper combustion
could occur and result in soot and/or excessive production of
carbon monoxide (CO), a colorless, odorless, toxic gas.
The size and position of the log set is critical to achieve
a safe, reliable and attractive flame pattern. Any attempt
to use a different log set in the fireplace will void the war-
ranty and will result in incomplete combustion, sooting
and poor flame quality.
Packaging List: Log set [rear log (A), left rear log (B), left
front log (C), center log (D)], embers (E) and rockwool (F)
1. Carefully remove the logs from their packaging and
ensure you have a complete set. The logs are fragile,
so handle them with care.
B
C
C
C
B
Figure 16
C
2. Install left rear log (B) onto the front half of log stand
B
 (see Burner Pan Diagram, Page 10). When installed
B
correctly it should sit firmly in place with the charred
surface facing the center of the firebox.
B
B
Figure 17
3. Place the rear log (A) onto log stands  and  (see Burner
Pan Diagram, Page 10). The charred surface of the log
should face the front.
4. Place the embers (E) on the burner pan. Using the larger
embers first, create a small pile on the elevated air deflec-
tor near the center and place them along the front edge of
the burner (leaving about 1/4" in between each ember and
a 2" gap in the center). It will not affect the performance,
but smaller embers may fall into the front air gap. Place
the rest of the embers throughout the firebox taking care
not to block off any secondary air holes or gas ports (see
example below for proper placement of embers).

A
A
A
B
B
D
D
F
A
D
D
E
A
Figure 18
5. Place the rockwool (F) over the gas ports and in between
the embers along the front of the firebox. The rockwool
can be placed over gas ports but do not cover the sec-
ondary air holes (see Burner Pan Diagram, Page 10).
F
F
F
E
E
E
Figure 19
6. Place the left front log (C) on log stand 3 (see Burner
Pan Diagram, Page 10) and the center log (D) spanning
from log stand 4 to the peg found on the right side of
rear log (A). When installed correctly, both logs should
A
sit firmly in place with the charred side facing forward.
A
Figure 20
A
NOTE: All logs are designed to fit only one way. For the
appliance to function properly, it is essential that the
logs be installed correctly. See below for an example of
a correctly burning Epic™ gas stove.
C
C
C
C
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
D
D
D
D