Log And Ember Placement - Lennox Hearth Products CI1500DVF Care And Operation Instructions Manual

LOG AND EMBER PLACEMENT

Carefully install this seven-piece log set into the firebox as shown in
these instructions. All logs should fit onto corresponding pins and/or
log stoppers. This will ensure a proper flame and safe combustion.
Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install logs.
This appliance is not meant to burn wood. Any
attempt to do so could cause irreparable damage
to your appliance and prove hazardous to your
safety.
The size and position on the log set was engineered
to give your appliance a safe, reliable and attrac-
tive flame pattern. Any attempt to use a different
log set in the stove will void the Warranty and will
result in incomplete combustion, sooting, and poor
flame quality.
If logs are not installed according to the directions
shown here, flame impingement and improper
combustion could occur and result in soot and/or
excessive production of carbon monoxide (CO), a
colorless, odorless, toxic gas.
1. Place the ember strip in front of the burner as shown in Figure 9.
It should be positioned all the way back (toward the sub-floor front
flange).
12
WARNING
WARNING
WARNING
WARNING
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Rear Log Stoppers
Ember
Strip
Figure 9
2. Place the largest log onto the rear log stoppers (see Figure 9).
Ensure that the grooves on the bottom of the log aligns onto the
corresponding places on the rear log stoppers. Push the log back
so that it is against the back of the rear log stoppers (see Figure
10).
Rear
Log
Figure 10
3. Place the left front log onto the corresponding burner pin and
sub-floor left tab as shown in Figure 11.
Left Front Log
Figure 11