Rinnai RF1200TW Operation & Installation Manual page 21

25 Min
TOP AND
SIDES
529 FROM
TOP OF
LOWEST PANEL
Before the outer glass can be fitted, the lower trim catches need
to be removed. This cannot be done once the glass has been
attached.
Remove the retainer springs from inside the engine and the
latches can then be removed from the outside of the engine.
Make sure that both inner and outer glass panels are
clean and all protective plastic has been removed
from the stainless steel louvre and all dust and
IMPORTANT
fingerprints etc. are removed before fixing outer
glass to engine - whilst removal of the inner glass is
possible there is no access to the top louvre or lower
divider panels.
Rinnai
499 FROM 479 FROM
UNDERSIDE OF TOP OF INNER
FRONT PANEL WINDOW FRAME
19
1190
1150
INNER WINDOW FRAME
(DOES NOT EXTEND TO TOP)
25 mm OVERLAP SHOWN
BUT NOT REQUIRED (BASE ONLY)
FOR FIRE INSTALLATION (MAY BE
REQUIRED AS PART OF
WATERPROOFING)
FRONT FIXING
FRONT
TRIM
RETAINER
RETAINER
SPRING
RF1200TW OIM