Sony DSLR-A700 User's Manual / Troubleshooting page 99

101 Recording menu 2
The default settings are marked with
~
.
Flash mode
You can select the flash mode.
For details on the operation
@"
page 32
~ Autoflash (AUTO)
For details, see page 73.
Fill-flash ( ~ )
Rear sync.
(REAR)
Wireless
(WL )
Flash control
You can select the flash control mode to set the amount of flash light.
~
ADI flash
A pre-flash is fired right before shooting, and the camera sets
the amount of flash light by measuring the amount of
reflected light from the pre-flash and the associated distance
information.
Pre-flash TIL
A pre-flash is fired right before shooting, and the camera sets
the amount of flash light by measuring only the amount of
reflected light from the pre-flash. The distance information is
not used in the calculation.
Manual flash
The built-in flash fires with certain amount of flash light
regardless of the brightness of a subject. This option is
disabled when [Autoflash] is selected.
ADI: Advanced Distance Integration
TTL: Through the lens
• When the distance between the subject and the external flash (not supplied) cannot be determined,
(wireless flash shooting using an external flash (not supplied), shooting with an off-camera flash using a
cable, shooting with a macro twin flash, etc.) the camera automatically selects Pre-flash TTL mode.
• Select [Pre-flash TTL] in the following cases, as the camera cannot obtain accurate distance information
with ADI flash.
- A wide panel is attached to the HVL-F36AM flash.
- A diffuser is used for flash shooting.
- A filter with an exposure factor, such as an NO filter, is used.
- A close-up lens is used.
• ADI flash is only available in combination with the lens that is provided with a distance encoder. To
determine the lens is equipped with a distance encoder, refer to the operating instructions supplied with
the lens.
•
99