Diamondshield Tm Removal And Installation - Mitsubishi WS-55517 Service Manual

MODELS: WS-55517 / WS-65517 / WS-73517
1. DiamondShield™ Removal Procedure
The appropriate disassembly procedure given below.
Note: Wear gloves when handling the DiamondShield™ to prevent finger prints.
2. DiamondShield™ Installation Procedure
To install the DiamondShieldTM, reverse the above Removal Procedure.
*(See the Parts List for DiamondShield™ part numbers)
SERVICING THE DIAMONDSHIELD™
1. Gently insert a small plastic card (such as a credit card or a
plastic putty knife) between the Diamond Shield
the clip to pry the clip loose.
2. From the edge of the trim, pull the brackets outward to open like
a hinge.
3. Carefully insert the small plastic card (or plastic putty knife) into
the gap at the side/center point of the Shield and pull the Shield
slightly away from the unit. Place your hands at the points
shown and gently bow the Shield toward you and remove from the
unit.
4. Close the two trim brackets at the sides.
TM
Page 11
and one end of