Table of Contents
Advertisement
Removal of the Lenticular Screen and Fresnel Lens
[VS-4543, VS-4544]
1. Remove the Screen Assy. [Fig. 2-1]
2. Remove 14 screws @ retaining the Screen Holder. [Fig. 5-1]
3. Remove 4 screws ©) retaining the PCB-CONTROL Cover.
4. Remove 10 screws © retaining the Frame Cover.
@
Screen Holder
®
©
PCB-CONTROL
Cover
Fig. 5-1
Installation of the Lenticular Screen and Fresnel Lens
[VS-4543, VS-4544]
Note: 1) Wear gloves when handling the Lenticular Screen and the Fresnel Lens. This prevents cuts and finger prints.
2) Do not place the Fresnel Lens in the sun. This can cause fire and heat related injuries.
3) Store in a dry place. High humidity causes deformation of the Lenticular Screen and Fresnel Lens.
1. Apply Double Coated Tape(# 096Z465Y 10) along the top front edge of the Fresnel Lens. [Fig. 5-2]
2. Set the Fresnel Lens on the top of the Lenticular Screen and apply pressure to the top edge, to join the screens
together.
Fresnel Lens
}+~+——— 36.8 inch ——>|
Top
Double Coated Tape
# 096Z465Y10
Fig. 5-2
Advertisement
Table of Contents
