Maintenance And Repair Instructions; Maintenance Schedule; Tine Removal And Replacement - Ryobi 510r Operator's Manual

4-cycle garden cultivator
Hide thumbs Also See for 510r:
Table of Contents

Advertisement

MAINTENANCE AND REPAIR INSTRUCTIONS

NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about
these procedures take your unit to an authorized
service dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.
FREQUENCY
Before Starting Engine
Every 10 Hours
1st Change at 10 Hours
Every 25 Hours there after
Every 25 Hours
10 hours on new engine
Every 50 Hours
Every 50 Hours

TINE REMOVAL AND REPLACEMENT

All 4 tines should be replaced at the same time because
they will wear evenly through normal use. Work on one
side at a time.
WARNING: To prevent serious personal
injury, always wear heavy gloves when
handling the tines.
1. Put the On/Off Stop Control in the STOP (O) position
and disconnect the spark plug wire.
2. Remove the clevis pin clips and clevis pins (Fig. 15).
3. Remove the tines and felt cushions from the shaft.
4. Clean and oil the shaft.
5. Replace the tines and felt cushions by reversing
steps 2 and 3 (Fig. 16).
NOTE: When installed correctly, the hubs on the tines
will face each other and the letter "R" stamped
on the tines will appear on the right side of the
cultivator and the letter "L" will appear on the
left side from the normal operating position. It is
important that the tines are installed correctly.
6. Repeat this procedure on the opposite side.
MAINTENANCE REQUIRED
Fill fuel tank with fresh fuel
Check oil
Clean and re-oil air filter.
Change oil
Change oil
Clean Spark Arrestor
Check rocker arm to valve clearance and adjust as required
Check rocker arm to valve clearance and adjust as required
Check spark plug condition and gap
WARNING: To prevent serious injury, never
do maintenance or repairs with unit running.
Always do maintenance and repairs on a
cool unit. Disconnect spark plug wire to
ensure the unit will not start.
Clevis Pin
Fig. 15
Fig. 16
REFER TO:
Page 9-10
Page 14
Page 15
Page 14
Page 14
Page 18
Page 16-17
Page 16-17
Page 18
Clevis Pin Clip
Felt Cushion
13

Advertisement

Table of Contents
loading

Table of Contents