Overview; Parts Identification; Projector - Sony SRX-T615 Operating Instructions Manual

Overview

Parts Identification

Projector

Front
a 8-inch duct attachment point
Attach an exhaust duct here.
b Lens lock lever
Locks or releases a lens.
c Lens attachment point
Attach a lens (not supplied) here.
For details on lens attachment or replacement, contact
your dealer or your local Sony representative.
Rear
a EMERGENCY switch
Forces the lamp to turn off (enters standby after
cooling).
4
Parts Identification
b Message display window
Displays various messages (page 25).
c Status indicators
Indicate the projector's status.
MAIN LAMP
Lit red Lit red
Lit green Blinking green
(rapid)
Lit green Lit green
Lit green Blinking green
(slow)
Blinking green Blinking green
(rapid) (rapid)
Tips
The IMB indicator lights red under normal
circumstances. However, this may change depending
on the options you install.
d Status lights
These operate when the server is connected.
e Power switch
Turns the projector's main power on (|) or off (a).
To turn the projector off
Wait for the lamp's cooling process to complete
before turning the power switch off.
For details, see "Turning Off the Projector"
(page 16).
Left side
a Lamp access panel (lamp grill) / intake vent / air
filter
A lamp access panel (lamp grill) / intake vent / air
filter is also located on the right side of the projector.
Projector status
Standby mode
Starting up
Power on (lamp lit)
Power on (lamp off)
Cooling
Connectors