Messages - Sony SRX-T615 Operating Instructions Manual

Symptom Cause
The image is The contrast and
dark. brightness settings
are incorrect.
The lamp output
setting is incorrect.
Controls
Symptom Cause
The main The projector and
screen of controller PC are not
SRX connected properly.
Controller
does not
appear.
Solution
Specify the correct
[Contrast] and
[Brightness] in the
[PICTURE CONTROL]
tab (page 20).
Specify the correct
[LAMP POWER] in the
[INSTALLATION] tab
(page 22).
Solution
Connect the connection
cables properly
(page 12).

Messages

The following messages appear in the message display
window on the rear of the projector.
Error messages also appear under [Warning Info] in the
main screen of SRX Controller.
Projector (rear)
Error messages are separated into the following three
categories based on severity.
If an error occurs, a message number and error message
appear in the display window.
Error (severity: high): The projector will be shut down
forcibly.
Warning (severity: medium): Operation will continue,
but the problem should be resolved as soon as
possible.
Info (severity: low)
If an error message appears, contact your dealer or your
local Sony representative with the message number and
error message.
Error (severity: high)
Message No.
Error 1
Error 2
Error 3
Error 4
Error 5
Error 6
Error 7
Error 8
Error 9
Error 10
Error 11
Message number
Error 1
PW_MAIN_SY12
Message
Message
PW_MAIN_SY12
PW_MAIN_SY26
PW_MAIN_SY7-1
PW_MAIN_SY7-2
PW_MAIN_FE3.3
PW_MAIN_FE2.5
PW_MAIN_FE1.8
PW_MAIN_FE1.2MX
PW_MAIN_FE1.0MX
PW_MAIN_FE1.2IN
PW_MAIN_FE1.5DC
Messages
25