Miscellaneous; Lamp Replacement Cycles; Troubleshooting - Sony SRX-T615 Operating Instructions Manual

Miscellaneous

Lamp Replacement
Cycles
The approximate lamp replacement cycle is as follows.
Model name
LKRM-U330 (330 W)
LKRM-U450 (450 W)
The approximate usage times for lamps is indicated by the
color of the lamp indicators at the top right of the SRX
Controller screen.
Lamp indicators
Usage time (%)
0 to 80
80 to 100
100 or more
Error
24
Lamp Replacement Cycles / Troubleshooting
Recommended cycle
3,000 hours
2,000 hours
Color
White
Yellow
Red
× mark

Troubleshooting

Check the following before requesting repairs.
If the problem persists, contact your dealer or your local
Sony representative.
Power
Symptom Cause
The power The main power is
does not turn not turned on.
on.
The projector is not
connected properly to
the controller PC.
The lamp's exhaust
duct is not connected.
"Error 52" Errors are occurring
appears. due to power supply
noise.
Images
Symptom Cause
The image does The connection
not appear. cables are
disconnected.
The input is not
selected properly.
The image is muted.
The ambient
temperature is too
high.
The color is The input signal
incorrect. mode is configured
incorrectly.
Solution
Set the power switch on
the rear of the projector
to the raised position
(page 14).
Connect the connection
cables properly
(page 12).
Contact your dealer or
your local Sony
representative.
After setting the breaker
on the rear of the
projector to the off
position for about
30 seconds, perform
verification of operation
again. If the problem
persists, contact your
dealer or your local Sony
representative.
Solution
Check the connections
(page 13).
Check that the input
signal is selected
properly under [INPUT
SELCT] in the
[SCREEN CONTROL]
block (page 17).
Click [OFF] for
[MUTING] in the
[SCREEN CONTROL]
block (page 8).
Adjust the ambient
temperature to within the
projector's operating
temperature range (5 °C
to 35 °C (41 °F to 95
°F)).
Based on the input
signal, specify the
correct [Signal Mode]
under [Input Source] in
the [PICTURE
CONTROL] tab
(page 20).