Connecting The Controller Pc; Connecting To The Network Connector - Sony SRX-T615 Operating Instructions Manual

6
When the following screen appears, click [Finish].
If you selected the [Launch the program] checkbox,
SRX Controller will start immediately.
This completes installation of SRX Controller.
When SRX Controller is installed, the ìStart SRX
Controller for SRX-T seriesî icon is created on your
desktop.
12

Connecting the Controller PC

Connecting the Controller
PC
Connect the controller PC to the NETWORK connector or
RS-232C connector on the projector, depending on your
operating environment.
Notes
If both the NETWORK connector (LAN) and the RS-232C
connector (COM) are connected at the same time,
communication errors may occur. Use only one connection
at a time.
Connecting to the NETWORK
Connector
Use a LAN cable (not supplied) to connect the
NETWORK connector on the projector to the LAN
connector on the controller PC.
to NETWORK
connector
LAN cable (crossover cable)
(not supplied)
to LAN connector
You can also use a LAN cable (straight) (not supplied) and
connect to a network via a hub.
Controller PC