Dispenser Switch; Dispenser Heater - Electrolux Built-in 42" Service Manual

To remove the duct door motor:
1. Manually rotate the motor cam until the cam lobe
points forward.
2. Remove the 2 Phillips-head screws from the motor
mounting bracket. (Photo shown with cam removed.)
3. Slide motor assembly to the left to clear the rear
mounting tabs.
4. Pull the motor forward while rotating it clockwise.
5. Disconnect the motor wire connector.
Caution: When assembling, ensure the duct door post is
in the outer channel of the cam, to avoid damage to the
duct door and/or cam.
Caution: When installing the motor, ensure the
motor mount is behind the side and bottom tabs,
or damage to the cam will occur.
Note: Before reapplying power, remove the switch
housing and rotate the motor cam clockwise by hand to
ensure proper door/cam operation. To avoid motor gear
damage, DO NOT rotate the motor cam counterclockwise.
The duct door motor operates at 120 VAC when energized
by the power control board (PCB). The motor has
resistance of approximately 2K W. Check at CN08 on the
terminal board, between pin # 4 (neutral) and pin # 6.

Dispenser Switch

The dispenser switch pad must be removed to access the
dispenser switch. Insert a fl at-blade screwdriver into the
bottom slot of the dispenser switch pad and lift up.
To remove the switch, lift it up at the bottom (see photo)
with a screwdriver. Release the switch from the tabs at the
top.
The switch is a normally open switch. Check for 5 VDC
at CN03 on the terminal board, between pin #3 and pin
#4, when the dispenser switch is open.

Dispenser Heater

The dispenser cavity heater is non serviceable. If
defective, the freezer door must be replaced. The amount
37
5995432258