Automatic Ice & Water Dispenser - Electrolux EQE5660A-B User Manual

20 www.electrolux.com
6. AUTOMATIC ICE & WATER DISPENSER
NOTE: The Automatic ice&water for EQE5660
model only
Using the ice maker after installation
The automatic ice making function pumps
water from the water tank located in the
refrigerator and dispenses it into the automatic
ice maker in the freezer.
The ice will then be dropped into the ice bin
located beneath the ice maker. If the water
tank is empty or lower than level, the ice maker
will automatically turn off after 3 attempts at
pumping water from the tank. The ice maker
indicator on the user interface shows the
operational status of the ice maker (Refer
control instructions).
Refilling the water tank
• The water tank must be placed on the door.
• Pour potable water through the funnel at the
lid of water tank.
• Ensure that ice maker and dispenser is
switched on.
Water
Priming the water supply system
1. Begin filling the system by pressing and
holding a drinking glass against the
dispenser.
2. Keep the glass in this position until water
comes out of the dispenser. It may take
about 1½ minutes.
3. Continue dispensing water for about four
minutes to flush the system and plumbing
connections of any impurities (stopping to
empty the glass as necessary).
Note: The water dispenser has a built-in device
that shuts off the water flow after three minutes
of continuous use. To reset this shut-off device,
simply release the dispenser paddle.
CAUTION
Do not fill the Water tank with anything
other then clean water (Filtered or
Mineral water). Soft drink, juice, tea
or hot water etc, can damage your
automatic icemaker. The Water tank
can withstand a maximum water
temperature of 60°C
Tip and Useful Information
Remove and clean ice bin and water
tank once a month, discarding unused
ice and water. This will ensure fresh ice
and smooth operation of your icemaker.
Make sure your refrigerator is level to
avoid uneven ice cubes.
Turning the ice maker on and off
IMPORTANT
Your ice maker is turned on at the
factory so it can work as soon as you
install your refrigerator. If you do not
fill the water tank, set the ice maker's
On/Off feature to Off; otherwise, the
ice maker's fill valve may make a loud
chattering noise when it attempts to
operate without water.
Ice production is controlled by the ice maker's
On/Off feature on the control panel. Pressing
the On/Off feature turns the ice maker on & off.
IMPORTANT
Turning off the ice maker simply d
isables ice making. You will still be able
to dispense existing ice, and you will
still be able to dispense water.