Electrolux Built-in 42" Service Manual page 55

Hide thumbs Also See for Built-in 42":

Table of Contents

Do Not Use

Note #1 (Showroom Mode)

In the showroom mode, the compressor and fans do not operate. The fresh food and freezer lights operate as normal

(ON when door is opened). The dispenser and dispenser display operate as normal. Temperature set points can be

changed. Press the DISPLAY TEMP pad to display the actual cabinet temperature. To exit the showroom mode, cycle

power OFF or enter test mode 1 5 to reset the unit.

Note: The showroom mode can also be entered outside of the service mode by simultaneously pressing the COLDER

pad on the FREEZER display and the WARMER pad on the REFRIGERATOR display for 3 seconds (the display

must be lit before pressing the pads).

Note #2 (HMI Self-Test)

Once the HMI self-test is started, all of the LEDs and seven segment LEDs will illuminate. The COLDER pad turns

off the seven segment LEDs and the WARMER pad turns off the SET LED for both the FREEZER and

REFRIGERATOR displays.

When all the available LEDs have been turned off for that specifi c temperature board, the COLDER and WARMER

pads on the REFRIGERATOR display must be held simultaneously for 3 seconds to exit the HMI self-test. This can

be done any time during the test.

Note #3 (Control and Sensor System Self-Test)

5995432258

Table of Contents