Samsung SNP-6320 User Manual page 80

setup screen
to use the motion Detection (mD) function
1. Select the <mD / va> type on the
<preset edit setup> tab.
2. Select the <motion detection> mode.
3. Select <on>.
4. Select the sensitivity of separating
movement from the background.
You can select 5 levels of sensitivity (very
low/low/normal/high/very high).
5. Select the size of the object for
observation.
• Minimum size : To restrict the
minimum movement to be observed,
select <minimum size> and enter
the width and height. The unit is
pixel, and you can select any value
equivalent to or higher than 32 x 32.
• Maximum size : To restrict the
maximum movement to be observed,
select <maximum size> and enter
the width and height. The unit is
pixels, and you can select any value up to 1920 x 1080.
Motions smaller than the specified minimum size or bigger than the maximum size are not
`
J
detected. To avoid unintended detections caused by great and small noises, set minimum/
maximum motion sizes appropriately in accordance to your environments.
Note that same motions on the same location can be differently detected in their detection size;
`
it is recommended to consider and include the tolerable difference when setting the minimum/
maximum detection sizes.
6. Set the area in which movement is detected.
You can drag the area on the screen. You can set up to 4 areas.
7. When done, click [apply (
Unlike the video analysis function, the motion detection function provides no overlay mark on the
`
J
screen. A yellow box appears at a side of the monitoring screen, and the operation function is
recorded in the system log.
80_ setup screen
)].