Installation & Connection; Connecting With Other Device; Preparing Adapter And Cable - Samsung SNP-6320 User Manual

installation & connection

connectinG witH otHer Device

preparing adapter and cable

Connect the camera to the power adaptor. Then, plug the power cord of the adaptor to the wall
J `
outlet.
Check out the rated voltage and current before making connections.
Rated Power
AC 24V
If applied with both PoE+ and AC 24V power supplies, the device is powered from the first
J `
engaged supply.
-
It is preferred to use single power supply of either one of PoE+ and AC 24V.
If connected to a switch device that provides PoE+ power, you don't need to apply a power source
`
of AC 24V supply.
Make sure the PoE device suffices PoE+ (IEEE 802.3at) specifications.
`
-
If your device is connected to the switch with the standard of PoE (IEEE 802.3af), then go to
the switch setup menu to "deactivate PoE".
For further information on switch device, refer to the manufacturer's manual.
-
It is recommended to use a cable that complies with the PoE+ spec.
If you use a PoE+ as a power, the boot time may vary depending on a switch model (by channel)
`
or a maker (as PoE+ connection time is included.).
The heater doesn't work with the PoE+ power supply. (SNP-6320H)
`
22_ installation & connection
D+ D- TXD+ TXD- GND
Allowable Input Voltage
AC 22V ~ 26V
Current Consumption
(SNP-6320 : AC 24V, 2.5A/
SNP-6320H : AC 24V, 3A)