No Response From Sentry Key Immobilizer Module - Dodge Ram 2004 Service Manual

COMMUNICATION
Symptom:

*NO RESPONSE FROM SENTRY KEY IMMOBILIZER MODULE

ATTEMPT TO COMMUNICATE WITH THE MIC
GROUND CIRCUIT OPEN
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
FUSED B(+) CIRCUIT OPEN
OPEN PCI BUS CIRCUIT
SENTRY KEY IMMOBILIZER MODULE
TEST
1 Turn the ignition on.
With the DRB, attempt to communicate with the Instrument Cluster.
Was the DRB able to I/D or communicate with the MIC?
Yes → Go To 2
→ Refer to the symptom list for problems related to no communica-
No
2 Turn the ignition off.
Disconnect the SKIM harness connector.
Using a 12-volt test light connected to 12-volts, probe the ground circuit.
Is the test light illuminated?
Yes → Go To 3
→ Repair the ground circuit for an open.
No
3 Turn the ignition off.
Disconnect the SKIM harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the Fused Ignition Switch
Output circuit.
Is the test light illuminated?
Yes → Go To 4
→ Repair the Fused Ignition Switch Output circuit for an open.
No
4 Turn the ignition off.
Disconnect the SKIM harness connector.
Using a 12-volt test light connected to ground, probe the Fused B(+) circuit.
Is the test light illuminated?
Yes → Go To 5
→ Repair the Fused B+ circuit for an open.
No
POSSIBLE CAUSES
ACTION
tion with the MIC.
Perform SKIS VERIFICATION.
Perform SKIS VERIFICATION.
Perform SKIS VERIFICATION.
Perform SKIS VERIFICATION.
292
APPLICABILITY
All
All
All
All