homexpert evohome Installation & User Manual page 9

!
Synchronisation
can take up to
4 minutes until
the current room
setpoint temperature
is displayed on the
Radiator Controller.
If BINDING is
not successful,
it is terminated
automatically after
approx. 10 minutes.
– or –
To cancel BINDING,
select EXIT using
the adjustment dial
and confirm with the
button.
Installation & User Guide
Bind the Radiator Controller to the
evohome Controller
1
2
3
4
5
6
7
8
9
1 2
Remove the adjustment dial
Open the battery clip and insert
the AA batteries supplied
Close the clip and replace the adjustment dial
Press the button once − it
should say UNBOUND
While UNBOUND is displayed press
and hold the button again for 5
seconds – it should say BIND
Press the button once – it
should say BINDING
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
The name of the allocated zone should
appear on the Radiator Controller display
when you press the
Either press the green tick
another Radiator Controller to the same
zone, or press the red cross
need to add another radiator to the zone.
4
button
to add
5
PRESS hold
onCE 5 SEC
7
if you don't
6
PRESS
onCE