Fuser Assembly Removal - Lexmark C540n Service Manual

Fuser assembly removal

See "Fuser assembly" on
1.
Remove the right cover assembly. See
2.
Remove the left cover. See
3.
Disconnect the two-wire fuser cable (A) from the LVPS.
4.
Position the fuser cable so that it can be pulled through from the front of the printer, and guide the cable
through to the front.
Warning: Be careful not to damage the cable by pulling too hard or cutting the cable insulation.
5.
Remove the screw and grounding washer (B) on the right side of the frame.
Note: Be careful not to lose the grounding washer.
6.
Disconnect the thermistor cables (C).
page 7-5 for the part number.
"Right cover assembly removal" on page
"Left cover assembly removal" on page
5025-2xx, 4xx
4-12.
4-6.
Repair information
4-29