Table of Contents
Advertisement
SenSit
70
Selecting the frequency, channel number
With the
buttons you can directly switch between the factory-
/
preset frequencies (channel presets). The display starts flashing. Your
selection becomes effective immediately.
Press the
SET
button to acknowledge your selection. The display stops
flashing. (If the
SET
new frequency automatically on switch-off.)
Note:
You can choose the content of the standard display i.e. whether the
frequency or the channel number is displayed (
of the standard display"). The receiver is factory-preset to show the
frequency setting as standard.
Adjusting the sensitvity (transmitters only)
Close talking distances, speakers with loud voices or loud music sequences
may cause overmodulation in the transmission link, resulting in distortion.
In this case, the "PEAK" warning of the EM 100's AF level display (as well as
the SK 100 transmitter's yellow audio peak indication LED) will light up. If,
on the other hand, the sensitivity is adjusted too low, the transmission link
will be undermodulated, which would result in a signal with high background
noise.
The sensitivity has to be adjusted such that the "PEAK" warning of the
receiver's AF level display only lights up during the loudest passages.
The following figures are a guide to the best settings:
Loud music/vocals:
Presentations:
Interviews:
Select the "SEnSit" menu by pressing the
appears on the display; after a short pause the current sensitivity setting
is displayed.
With the
buttons you can now select a different setting. The
/
sensitivity can be adjusted in 10-dB steps from 0 to -30 dB. The new
setting starts flashing on the display and becomes effective immediately.
Press the
SET
button to return to the top menu level. The display
then switches back to the standard display.
button is not pressed, the receiver will store the
-30 / -20 dB
-20 / -10 dB
-10 / 0 dB
SET
"Selecting the content
button until "SEnSit"
Hide quick links:
Advertisement
Table of Contents
