Sennheiser Evolution EW100 Instruction Manual page 12

56
Switching the receiver on/off
Slide back the cover plate
Press the ON/OFF
up.
To switch the receiver off, press the
on the display. You can then release the button. The red LED goes
off.
Signal and battery status indication
The green LED at the top of the EK 100 receiver indicates that an RF
signal is being received.
Battery status indication
The red LED provides information on the (remaining) battery capacity:
LED lit up:
The receiver is switched on and the battery capacity is sufficient.
LED flashing:
The battery is going flat! You should immediately replace the battery.
Attachment of the receiver to clothing
The EK 100 receiver is best attached to e.g. the belt with clip
The clip is detachable so that you can also attach the receiver with the antenna
pointing downwards. To do so, withdraw the clip from its fixing points and
attach it the other way round.
Attachment of the receiver to a camera
Use the supplied camera kit (self-adhesive Velcro tape) to attach the receiver
to a camera. Remove the clip
the camera. Ensure that the surfaces are clean and free from grease.
(Note: We would suggest using the "hook" Velcro on the receiver and the
"loop" Velcro on the camera.)
.
button to switch the receiver on. The red LED lights
ON/OFF
and stick the Velcro tape to the receiver and
button until "OFF" appears
.