Installation and Setup
Mounting the Camera
Adjusting the Camera: FOV (Field of View) and Focus
Adjusting the Field of View
24
Note
You can connect your camera to a network or use any type of CAT5 cable to
connect it directly to a PC or laptop.
Surface Mount
1.
Secure the skirt to the ceiling (using
appropriate screws, not supplied) or to the
wall using the supplied screws.
Note
When mounting, you must use screws
that are able to support at least three
times the weight of the camera.
2.
Connect the wires (see
Wiring
on page 21).
3.
Rotate and align the yellow label (
on the camera assembly with the yellow
label on the skirt.
4.
Secure the camera assembly to the skirt by
pushing it into the skirt, then twisting it
clockwise until it clicks securely into place.
5.
Adjust the camera's field of view, as
needed (see
Adjusting the Camera: FOV
(Field of View) and Focus
6.
Install the turret by clicking it into place.
7.
Install the bubble by placing it on the camera with the tabs to the left of the slots, then
turning it clockwise until the tabs click securely into place.
To adjust your camera's field of view:
1.
Verify that power is supplied to your camera.
Connecting the
)
on page 24).
Skirt
Screws
(supplied)
Camera
assembly
Turret
Dome bubble