Installation and Setup
22
2.
Connect to the power supply (see
connector that was shipped with your camera and make the necessary connections.
3.
Plug the power supply into an appropriate power source. The LED on the RJ45 jack
illuminates when the camera receives power. If it does not illuminate, check the
terminal block connections and the power source.
Note
To ensure satisfactory performance, it is recommended that you use a UPS
source when connecting the camera to a 24 V AC power source.
Figure 2-3
Camera and Cables
Back view of camera
Figure 2-3
on
24 V AC power
page
22). Locate the two-pin green
RJ45 Ethernet network
connection (using 10Base T
or 100Base TX cable). See
Connecting to a Network
with an RJ-45 Ethernet
Connector
on page
more information.
Also used for Power over
Ethernet (PoE 802.3af).
23
for