Safety Precautions - Stanley IW12 Service Manual

To avoid serious injury or death
Wear Eye
Read the Manual
Protection
Wear Ear
Wear Dust Mask
Protection
• The operator must start in a work area without bystanders. Flying debris can cause serious injury.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor. Establish a training program
for all operators to ensure safe operation.
• Always wear safety equipment such as goggles, ear and head protection, and safety shoes at all times when operating
the tool. Use gloves and aprons when necessary.
• The operator must be familiar with all prohibited work areas such as excessive slopes and dangerous terrain conditions.
• Maintain proper footing and balance at all times.
• Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engagement of the tool can
cause serious injury.
• Always connect hoses to the tool hose couplers before energizing the hydraulic power source. Be sure all hose connec-
tions are tight and are in good condition.
• Do not operate the tool at oil temperatures above 140°F/60°C. Operation at higher temperatures can cause higher than
normal temperatures at the tool which can result in operator discomfort.
• Do not operate a damaged, improperly adjusted, or incompletely assembled impact wrench.
• Never wear loose clothing that can get entangled in the working parts of the tool.
• Keep all parts of your body away from the rotating parts. Long hair or loose clothing can become drawn into rotating
components.
• Always use accessories that conform to the specifi cations given in the OPERATION section of this manual.
• Do not reverse impact wrench rotation direction by changing fl uid fl ow direction.
• Release the trigger if the power supply has been interrupted.
• When working near electrical conductors, always assume that all conductors are energized and that insulation, clothing
and hoses can conduct electricity. Use hose labeled and certifi ed as non-conductive.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by au-
thorized and properly trained personnel.

SAFETY PRECAUTIONS

Tool operators and maintenance personnel must always comply with the safety
precautions given in this manual and on the stickers and tags attached to the tool
and hose.
These safety precautions are given for your safety. Review them carefully before
operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specifi c
work area and local safety regulations. If so, place the added precautions in the
space provided on page 5.
The model IW12 Hydraulic Impact Wrench will provide safe and dependable service
if operated in accordance with the instructions given in this manual. Read and un-
derstand this manual and any stickers and tags attached to the tool and hose before
operation. Failure to do so could result in personal injury or equipment
damage.
47351
6