Dialing To Dual Isps - D-Link DI-304 User Manual

DI-304ISDN Remote Router
IP Address Assignment Method (IPCP)

Dialing to Dual ISPs

Most configuration parameters are the same as last section. This page provides an
"Enable Dual ISPs Function" check box and adds a secondary ISP Setup section.
Check the box and enter the second ISP information.
ISP Access Setup
PPP/MP Setup
? PAP or CHAP - Set the PPP session to use the PAP or CHAP
protocols to negotiate the username and password with the ISP.
♦
Idle Timeout – Idle timeout means the router will disconnect after being idle
for a preset amount of time. The default is 180 seconds. If you set the time to 0,
the ISDN connection will remain always connected to the ISP.
♦
Fixed IP and Fixed IP Address – In most environments you should not
change the default settings as most ISPs provide a dynamic IP address for the
router when it connects to the ISP. If your ISP provides a fixed IP address,
check Yes and enter the assigned IP address in the Fixed IP Address field.
♦
ISP Name – Enter the Internet Service Provider Name.
♦
Username – Enter the username obtained from your ISP provider.
♦
Password – Enter the password obtained from your ISP provider.
♦
Link Type – You have three selections:
? Link Disable – Disables the ISDN dial-out function.
? Dialup 128Kbps – Uses both ISDN B channels for Internet access.
30