DI-304/DI-304M ISDN Remote Router
User Account and Authentication
Callback Function
The callback function provides a callback service for the dial-in user. The router owner
will be charged the connection fee by the telecom.
♦
Dial-In Username – The "???" means the access account has not set up yet.
If an access account has been configured, the username will be shown.
♦
Status – The symbol "v" means the account is active, "x" means inactive.
Click the index number of an account to open an individual setup page for detail
setting.
♦
Check to enable the user account – Check this item to activate the
individual user account.
♦
Username – Specify a username for the specific dial-in user.
♦
Password – Specify a password for the specific dial-in user.
♦
Idle Timeout – Default setting is 300 seconds. When a dial-in connection has
been idled longer than the time limit, the router will drop the connection.
♦
Check to enable CLID authentication – For extra security, enables the
option to allow the dial-in user to call only from a specific number. CLID
stands for Calling Line Identification.
♦
Peer ISDN Number – If CLID authentication has been enabled, enter the
dial-in user's ISDN number.
♦
Check to enable the Callback function – Enable the callback function.
♦
Specify the callback number – This option is for extra security. Once
enabled, the router will only call back to the specified ISDN number defined in
the next parameter, Callback Number.
♦
Callback Number – If the previous option has been enabled, enter the dial-in
user's ISDN line number here.
♦
Check to enable Callback Budget Control – Enable the callback budget
control.
40