Figure 6-7 Menu 3.2.1 - Ip Alias Setup; Table 6-5 Ip Alias Setup Menu Fields - ZyXEL Communications ZyWall 100 User Manual

Press Space Bar to Toggle.
Use the instructions in the following table to configure IP Alias parameters.
FIELD
IP Alias
IP Address
IP Subnet Mask
RIP Direction
Version
Incoming
Protocol Filters
Outgoing
Protocol Filters
LAN Setup
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Figure 6-7 Menu 3.2.1 — IP Alias Setup

Table 6-5 IP Alias Setup Menu Fields

Choose Yes to configure the LAN network for the ZyWALL.
Enter the IP address of your ZyWALL in dotted decimal notation.
Your ZyWALL will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL.
Press [SPACE BAR] and then [ENTER] to select the RIP
direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are
RIP-1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyWALL.
Enter the filter set(s) you wish to apply to the outgoing traffic
between this node and the ZyWALL.
ZyWALL 100 Internet Security Gateway
Version= N/A
Version= N/A
DESCRIPTION DEFAULT
Yes
192.168.2.1
255.255.255.0
None
RIP-1
1
2
6-9