Setting The Limited Functions Mode From The Service Call Message Screen - Canon imageRUNNER C5051 ADVANCE Maintenance Manual

Setting the Limited Functions Mode from the Service Call Message Screen

If the Service Call Message screen appears indicating a malfunction of a Finisher mode, you can clear it by turning the Limited
Functions Mode 'On' to temporarily limit the use of the finishing modes. However, after the Limited Functions Mode is
deactivated, the Service Call Message screen may appear again, unless the cause of the malfunction is removed.
If you shutdown the machine when there is a job waiting to print, that job is erased.
2
If you set Limited Functions Mode to 'On' from the Service Call Message screen, Limited Functions Mode in Management Settings (from
the Settings/Registration screen) is also set to 'On' . (See e-Manual > Security.)
1
Press [Limited Fnctns Mode] .
2
Press [Yes] .
A message prompting you press [Shutdown] and to turn the main power switch back ON appears.
3
Press the main power switch to the " " side .
When operating the main power switch, open the main power switch cover.
4
Wait at least 10 seconds after the Main Power Indicator is turned off, and then turn the main
power switch back to "I" side .
When operating the main power switch, open the main power switch cover.
The machine starts up in the Limited Functions mode.
2-80
Service Call Message